Publicité
Les langues disponibles
Les langues disponibles
CAUTION
Never apply force to the wheel spin shaft when
moving the machine.
INSTALLATION
WARNING
Carry out the unpacking, assembly and installation
operations indicated below with great care.
Failure to comply with these instructions could
damage the machine and put the operator at risk.
Remove the original packing materials after posi-
tioning them as indicated on the packaging and
keep them intact so that the machine can be safely
shipped at a later date if necessary.
WARNING
The place where the machine is to be installed must
conform to applicable safety at work regulations.
In particular, the machine must only be installed
and used in protected environments where there
is no risk of dripping onto it.
The floor must be strong enough to support a load
equal to the weight of the equipment plus the
maximum load allowed. The support base on the
floor and the envisaged fixing means must also be
taken into account.
IMPORTANT:
for the correct and safe operation of the machine,
the lighting level in the place of use should be at
least 300 lux.
Environmental operating conditions must comply
with the following requirements:
- Relative humidity ranging from 30% to 80% (with-
out condensation).
- Temperature ranging from 5° to +40°C.
WARNING
The machine must not be operated in potentially
explosive atmospheres.
The machine is supplied partially disassembled and
is to be assembled according to the procedures
described below.
44
Monitor support and monitor
touchscreen assembly
-
connect the button cable, leading out from the
weight carrier cover, to the respective connector
under the monitor mount (A, fig.5);
-
fit the two galvanised spacers in the holes in
the weight carrier cover, then fasten the monitor
mount (A, fig. 5) using the two M8X50 screws
and the two M8 washers included (B, fig. 5);
-
remove the monitor from its packaging and fasten
to the mounting flange, using the four screws
included with the machine (A, fig. 6).
-
connect the USB, signal and power cables to the
rear panel of the monitor (B, C and D fig. 6).
A
B
S78 Touch - Operator's manual
5
C
6
D
Publicité
Chapitres
