SICE S 78 TOUCH Manuel D'instructions page 63

5.
AUTOMATIC CLAMPING SYSTEM HUB
REMOVAL/ASSEMBLY MODE
6.
CONFIGURATION PROGRAMMES
1. SPIN COUNTER
Three counters are displayed on the screen:
-
the number of partial spins made since the last
manual reset;
-
the total number of spins performed by the
machine since its first start-up;
-
the number of wheel spins performed since the
last sensitivity calibration.
If the Control Weig suite is enabled, the spin coun-
ter icon in the Utility programmes menu becomes
and displays:
-
the total number of spins performed by the
machine since its first start-up;
-
the number of partial spins made since the last
manual reset;
S78 Touch - Operator's manual
-
the total weight quantity saved by the machine
since its first start-up;
-
the partial weight quantity saved since the last
manual reset;
- two histograms that compare the quantity
of weight required if the "Weight Reduction"
programme
the quantity required if the "Weight Reduction"
programme
entire service life of the machine for clip and
adhesive weights.
The Reset button
the partial spin counters and the weight quantity
saved.
To quit the counter display, press the Exit button
.
If connected to an approved printer, the Print menu
secondary control key
the print procedure for the "Weight Reduction"
programme.
2. MANUAL ENTRY OF WHEEL DIMENSIONS
In the event of failure of the internal and/or external
laser sensors or incorrect measurement of one of the
three working dimensions, the geometric data can
be entered manually using the following procedure.
A screen is displayed with the default or previously
measured wheel dimensions.
Using the number pad, one or more of the wheel
dimensions can be changed.
- The wheel balancer prepares for manual entry of
the distance.
- Using the number pad, change the distance dis-
played by entering the distance measured with
(red bar) is not used and
(green bar) is used for the
can be used to reset
can be used to start
63