Feedback Window; Shutting Down; Using The Automatic Wheel Clamping System C - SICE S 78 TOUCH Manuel D'instructions

- from the print menu, the PDF file can be down-
loaded onto a USB key connected to the machine
by pressing the button
Connect the USB
After pressing the button, the following image
screen while the file is being saved to the USB
key. The USB key may be disconnected from the
machine once the image is no longer displayed.
The file is saved to the USB key with a unique
file name, consisting of the total count of spins
performed by the machine (e.g. 000014) and,
if required, a custom file name entered by the
operator (customer name or vehicle license plate
number).

FEEDBACK WINDOW

The feedback window, as shown in the figure below,
displays the following information:
- Name of operator (see the "Customisation"
section).
- Wheel dimensions during the last spin: white if
measured automatically; or yellow if set manually.
or grey if calculated statistically and NOT acquired
automatically by the machine.
CAUTION
This data (in grey) may NOT correspond with the
wheel's rated dimensions. This display does NOT
indicate a machine error (as the dimensions are
calculated statistically and NOT automatically
measured) or an error in the unbalance display.
- The status of the clamping brake (enabled or not
enabled)
- Enabling of the WR programme
- The selected balancing environment (ref. "Configu-
ration Programmes" section)
54
.
key if the image
appears on the screen.
is displayed on the

SHUTTING DOWN

This function starts the shutdown process which
protects the Windows operating system installed
on the mother board and depowers the machine.
Proceed as follows:
Press the Enter button
-
- Wait for the PC to be turned off completely as
confirmed by an intermittent beep.
- Press the switch on the back of the body (C, Fig.
5).
USING THE AUTOMATIC WHEEL
CLAMPING SYSTEM C
NOTE:
After every power on, the first time the automatic
wheel clamping system is activated using the pedal,
the machine will perform a calibration by automati-
cally moving the two ratchets located on the hub
towards the outer side. When calibration is complete,
the operator can use the machine as described below.
Wheel locking procedure with the automatic C:
Centring with cone at front
- Fit the wheel on the shaft, sliding it into place
until it rests against the flange.
- Fit the most suitable cone on the shaft and insert
it into the central hole of the wheel.
- Fit the locking device by making it slide on the
hub until it comes into contact with the cone.
- Press the control pedal for at least one second.
Centring with cone at rear
- Fit the most suitable cone for the central hole of
the wheel on the shaft.
- Fit the wheel onto the cone, sliding it into place
until the cone comes into contact with the plate
that holds the spring.
- Apply the protective cap to the sleeve.
- Fit the locking device by making it slide on the
hub until it comes into contact with the wheel.
S78 Touch - Operator's manual
.