Wheel Spin And Automatic Dimension Measurement - SICE S 78 TOUCH Manuel D'instructions

- Press the control pedal for at least one second.
Wheel release
- Press the control pedal for at least one second
to release the wheel from the flange.
Centring with flanges
C hub removal
- Keep the Stop button
keypad pressed for at least 3 seconds to lock the
wheel-holder shaft and the internal devices.
- Insert the C special key provided with the machine
in the C hub hole (Fig. 12).
- Unscrew the C hub completely.
- Mount the flange on the shaft and lock it with the
two screws (A, Fig. 13) using the CH 6 wrench.
A
-
Lock the wheel onto the flange as usual.
IMPORTANT
To work without the hub removed previously the
machine must be set in flange mode as described
in the "CONFIGURATION PROGRAMMES" section.
S78 Touch - Operator's manual
C hub mounting
Proceed as follows to remount the C hub:
- Go to the utility and configuration programmes
and press the
wheel-holder shaft and the internal devices.
- Screw the C hub manually until it reaches the
end position.
- Tighten the C hub by inserting the C special
on the
wrench into the C hub hole (Fig. 14).
12
WHEEL SPIN AND AUTOMATIC
DIMENSION MEASUREMENT
Wheel spin takes place automatically by lowering the
guard or pressing the Start button
the guard lowered.
During the spin, the balancer, using the front and rear
laser sensors, will process the rim dimensions using a
special software for the final unbalance calculation.
At the end of the spin, the rated dimensions of
the wheel are displayed in the feedback window,
specifically:
- The nominal rim width (only for dyn, sta, alu3,
13
alu4 and alu5 programs).
- The nominal rim diameter.
- The distance from the body to the inner edge of
the rim.
Note: at the end of the spin, if the automatic posi-
tion search function is enabled, the wheel may spin
with the guard raised.
NOTE
If the width measurement is highlighted in
icon to block the
14
with
55