Spin Type; Main Control Keypad; Secondary Control Keypad - SICE S 78 TOUCH Manuel D'instructions

SPIN TYPE

The working environment has different spin
types that the operator can select based on his
requirements, i.e.:
•
detection and radial run-out acquisition
of the complete wheel and rim
•
detection and radial run-out acquisition
of the complete wheel and rim as well
as lateral run-out of the wheel and rim
By checking this FLAG, the machine cycle time in-
creases as data regarding the geometry of the
wheel and rim being examined is acquired.

MAIN CONTROL KEYPAD

The main control keypad has the following buttons:
1.
Help button
- recalls information on the current video page to
the screen. If an error message is displayed, the
first piece of information displayed refers to the
error list. The instructions called up by this icon
integrate (but do not replace) this User Manual.
2.
Automatic dimensions button
- This enables automatic dimension measurement
after which the icon is disabled at the end of
the balancing cycle (ie. dimension reading is not
repeated until the button is re-enabled).
- This displays the page for manual entry of dimen-
sions if the laser sensors have been disabled (see
the "Wheel balancer parameter configuration"
52
: wheel unbalance
: wheel unbalance
section).
3.
Utility and configuration menu button
- This groups all the machine Utility and Configura-
tion programmes.
4.
Live button
- This is used to check and/or modify the balancing
planes measured by the processing unit.
When the machine is switched on, the button is
NOT present as a spin must be performed with
dimension acquisition enabled;
5.
Start button
- This starts the unbalance measurement cycle
when the guard is lowered.
6.
Stop button
- This stops the wheel for 50 seconds to allow wheel
mounting/demounting or weight application.
- Interrupts the unbalance measuring cycle.

SECONDARY CONTROL KEYPAD

The secondary control keypad can be used to quickly
modify machine status and consists of the following
five buttons:
1.
enables/disables the Weight Reduction suite:
- Select this button to activate the Weight Reduction
programme for weight saving consisting of two
balancing modes:
optimised mode for fast vehicle
wheels;
S78 Touch - Operator's manual