SICE S 78 TOUCH Manuel D'instructions page 65

the radial run-out of the rim (1st harmonic);
-
the radial run-out of the rim peak-to-peak;
-
the radial run-out of the tyre (1st harmonic);
-
the radial run-out of the tyre peak-to-peak;
- the wave forms show the progress of the wheel
runout.
If a rim is mounted, the following icons are displayed
at the end of the spin indicating:
-
the radial run-out of the inner tyre bead (1
harmonic);
-
the radial run-out of the inner tyre bead (peak-
peak);
-
the radial run-out of the outer tyre bead (1
harmonic);
S78 Touch - Operator's manual
-
the radial run-out of the outer tyre bead (peak-
peak);
-
the lateral run-out of the rim (1
-
the lateral run-out of the rim (peak-to-peak).
Note: The vertical mobile bar that appears in the
graphs shows the vertical axis at 12 o'clock.
IMPORTANT: If present, all the adhesive
weights fixed to the inner surface of the rim
and arranged along the laser sensor scanning
area must be removed before determining the
runout measurement cycle.
If a wheel assembly is mounted where geometric
deformation has been found in both the rim and
st
tyre, the effects of this on the wheel assembly may
be minimised by compensating the deformation of
the rim with the deformation of the tyre.
Notification of Geometric matching is given with an
end of measurement cycle message with one of the
following indications:
- Matching not recommended
- Matching recommended
If you want to perform Geometric matching,
select the ROD Matching icon
- bring the valve to the 12 o'clock position and
st
press the
on the monitor;
harmonic);
st
or button
.
65