SICE S 78 TOUCH Manuel D'instructions page 64

a tape measure between the right edge of the
body and the inner edge of the rim (Fig. 20).
- press the button on the monitor to confirm
and switch to the width value entry phase;
- Change the displayed value to the value measured
using the manual calliper (Fig. 21).
- press the button on the monitor to confirm
and switch to the diameter value entry phase;
- Change the value of the diameter displayed by
entering the value indicated on the tyre using
the keypad.
64
Press the Exit
-
manual data setting.
Note: When dimensions are set manually, clip or
adhesive weights must be applied manually in the
12 o'clock position.
3. Suite WHEEL DIAGNOSIS PROGRAMME
3.1. Radial and lateral runout measurement
This function is used to determine the causes of
20
disturbance (vibration) generated by geometric
deformation of the rim and/or tyre, which may still
persist even after a thorough balancing procedure.
The machine indicates that the procedure needs to
be performed by displaying the following warning
light
perform the procedure whenever considered necessary.
To do this, perform a spin.
If a wheel assembly is mounted, the following icons
are displayed on the screen at the end of the spin
indicating:
-
the radial run-out of the wheel (1st harmonic);
-
21
the radial run-out of the wheel peak-to-peak;
-
the lateral run-out of the wheel (1st harmonic);
-
the lateral run-out of the wheel peak-to-peak;
-
button to terminate the
. The operator can decide to
S78 Touch - Operator's manual