Utility And Configuration Programmes - SICE S 78 TOUCH Manuel D'instructions

To access the environment "manual entry of wheel
dimensions", press the FEEDBACK WINDOW on the
touch screen monitor in correspondence of the
wheel dimensions from the last spin.
- perform a spin;
- Place the clip weight in the 12 o'clock position.
Motorcycle ALU Programme
Proceed as follows to balance motorcycle wheels
dynamically using adhesive weights:
- follow the instructions for mounting the motorcycle
adapter described in the MOTORCYCLE DYNAMIC
PROGRAMME.
- Select the MOTO environment using the
icon located in the secondary
control keypad.
- Select the ALU 3 balancing programme directly
from the touch screen monitor;
Now the corresponding balancing planes are displayed
on the rim on the screen.
Proceed as described previously for the "Motorcycle
Dynamic" programme.
- place the adhesive weight in the 12 o'clock posi-
tion.
Best results can be achieved if the adhesive weights
are positioned with the outer edge being flush with
the rim edge.
Split Weight Programme
Some rims have spokes so wide that it is not possible
to place adhesive weights next to them; a program
which divides the counterweights into two parts has
been introduced to solve this problem.
In this case, when the centred position is reached
and it becomes obvious that the balancing weight
will have to be applied in line with a spoke, proceed
as follows:
- Remain in the centred position.
- the machine will display the split weight
button on the main working
screen;
- press the
ternatively displays the possible spoke dimensions:
62
button in sequence al-
small
, large
(selection disabled);
- simultaneously, after selecting the spoke type the
machine will display the two new counterweights
to be applied;
- apply two new counterweights in the positions
indicated at 12 o'clock.
The weight division operations can be performed on
both balancing sides.
UTILITY AND CONFIGURATION
PROGRAMMES
The Utility programmes are all the functions of the
machine that are useful for its operation but are not
strictly connected to its normal operation.
To display the list of Utility programmes, select the
Utility and Configuration programmes icon.
The programmes in this sub-menu are now available:
1.
SPIN COUNTER
2.
SET MANUAL WHEEL DIMENSIONS
3.
WHEEL DIAGNOSIS PROGRAMME
4.
UNBALANCE OPTIMISATION PROGRAMME
S78 Touch - Operator's manual
, medium
or OFF