Tips And Advice On Installation - SOMFY MAESTRIA+ 50 io Notice D'utilisation

EN
2. 3. 6.
product are set.
A. PROGRAMMING OF THE PREPROGRAMMED SOMFY IO-HOMECONTROL
Press the PROG button of the preprogrammed control
-
point: the driven product performs a brief up and down
B. PROGRAMMING OF A NON-PREPROGRAMMED CONTROL POINT
Switch off the power supply (the pre-programmed
1)
control point is deleted).
Switch the mains power supply back on. The driven
2)
Simultaneously press the "Up" and "Down" buttons of
3)
the control point to be programmed until the driven
4)
the driven product performs a brief up and down
movement; the control point is programmed.

2. 4. TIPS AND ADVICE ON INSTALLATION

2. 4. 1. Questions about the drive?
Observations
The driven product The wiring is incorrect.
does not operate.
The drive's overheating protection
has tripped.
The cable used is not compliant.
The Somfy io control point battery is
low.
The control point is not compatible.
The Somfy io control point being used
is not programmed in the drive.
The driven product The ring is not correctly installed.
stops too soon.
The end limits are incorrectly
programmed.
2. 4. 2. Re-setting the end limits
The following steps apply only for end limits that are set manually.
A. READJUSTMENT OF END LIMITS SET IN MANUAL MODE
Place the driven product in its end limit position to be
1)
Press and hold the "Up" and "Down" buttons
2)
simultaneously for 5 seconds until the driven product
Place the driven product in its new end limit position
3)
using the "Up" or "Down" buttons.
To validate the setting, press the "my" button until the
4)
58
Possible causes
Non contractual images
local control point
®
LOCAL CONTROL POINT
®
PROG.
1)
OFF
3)
Solutions
Check the wiring and modify as required.
Wait for the drive to cool down.
Check the cable and make sure that it has
3 conductors.
Check the battery and replace it as
required.
Check the compatibility and replace the
control point as required.
Use a programmed control point or
program this control point.
Secure the ring correctly.
Reset the end limits.
1)
3)
Copyright © 2015 Somfy SAS. All rights reserved.
2)
ON
4)
PROG.
2)
5 sec.
4)