Wiring; Set-Up - SOMFY MAESTRIA+ 50 io Notice D'utilisation

Round head drive
For drives greater than 25 Nm, use an adapted
support referenced by Somfy.
Install the support
3)
removable end caps
Slide the tube-drive-removable end cap assembly into
4)
the head rail.

2. 2. WIRING

Cables routed through a metal internal wall must be protected and insulated by sleeving
or sheathing.
Secure the cables to prevent any contact with moving parts.
If the drive is used outdoors and if the power supply cable is of the H05-VVF type, run the
cable in a UV-resistant duct, e.g. trunking.
Leave the drive power supply cable accessible: it must be easily replaceable.
Always make a loop in the power supply cable on the outside to prevent water from
entering the drive.
Switch the power supply off.
1)
Connect the drive according to the information
2)
provided in the table below:
Neutral (N)
230 V 50 Hz

2. 3. SET-UP

This guide describes drive set-up using a Somfy io-homecontrol
io-homecontrol local control point is a one-way radio transmitter
®
2. 3. 1.
Power must only be supplied to one drive at a time.
seconds on a single driven product to identify the drive's status:
Reaction 1:
The end limits have been set and no control point is programmed.
See section "Preprogramming of the Somfy io-homecontrol
-
section "Programming of the Somfy io-homecontrol
Reaction 2:
when the buttons on the control point are pressed.
The end limits have not been set and no control point is programmed.
See section Preprogramming of the Somfy io-homecontrol
-
Reaction 3:
buttons on the control point are pressed.
The set-up procedure is complete.
To modify the advanced settings, see section "Setting advanced sections" (§2. 3. 5).
-
Copyright © 2015 Somfy SAS. All rights reserved.
on the drive head, then the
i
.
k
Cable
Phase (L)
Blue Brown
1)
k
2)
1)
Earth ( )
Green-Yellow
local control point" (§2. 3. 2) then
®
local control point" (§2. 3. 6 A).
®
local control point (§2. 3. 2).
®
Non contractual images
i
2)
OFF
L N
230 V 50 Hz
local control point. A Somfy
®
.
EN
53