Installation With Vehicle Lap Belt Only - Britax ONE4LIFE CLICKTIGHT Guide D'utilisation

9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and strap is not twisted.
9 Base of child restraint sits flat on vehicle sit.
9 Recline indicator is still within the correct section for FORWARD-
facing, after securing the child.
9 Child restraint cannot be moved front to back or side to side more
than 2.5 cm (1 in.) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
9 The anti-rerbound bar MUST be removed.
NOTE: If the child restraint does not meet the above criteria,
repeat the installation steps or use a different seating
location in your vehicle.

Installation with Vehicle Lap Belt Only

1. Extend the top tether strap
by lifting on the top tether
adjuster.
2. Unhook the top tether
hook from the back of the
child restraint and place it
up and over the seatback.
3. Recline child restraint to
the appropriate position.
Refer to page 15 to
determine appropriate
recline position.
4. Place child restraint
FORWARD-facing on
the vehicle seat so that
bottom of the base sits
flat on the vehicle seat.
5. Ensure that no more than
7.5 cm (3 in) of the base
hangs over the front edge
of the vehicle seat.
6. Open the CLICKTIGHT
door. Squeeze the
CLICKTIGHT release
buttons underneath
the front cover flap and
lift to open.
7.5 cm
29