Lap Belt Installation - Britax Pavilion 65-G3 Guide D'utilisation

Siège auto bébé
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Rear-Facing Installation

Lap Belt Installation

Before You Begin:
• Check that your vehicle belt is compatible for use with child
seats. See pages 6 – 8 for more information.
• Recline this child seat to position 3 and place rear-facing on the
vehicle seat (see page 15).
* When properly installed in the rear-facing
position, the back angle of the child seat
should be at least 30˚ for children and up
to 45˚ from vertical for infants unable to
maintain head and neck control (not to
exceed 45˚) when the car is parked on a
level surface. Use the blue line as a guide
to achieve the proper recline angle for rear-
facing installations. The blue line will be parallel to the ground
when the child seat angle is at the center of the angle range (30
– 45˚). If necessary, the proper recline angle can be achieved by
placing a rolled towel or pool noodle in the vehicle seat bight.
• Britax recommends that the tether be used when installing the
child seat rear-facing. Using the tether will improve the stability
of the child seat and reduce the risk of injury. Check your
vehicle owner's manual for tether anchor locations. See page
18 for possible rear-facing tether configurations.
Install with the lap belt as shown above.
IMPORTANT:
• The vehicle seat belt must pass in front of the harness
buckle strap.
• DO NOT use lock-offs for lap belt installations.
• The buckle should be in the inner slot for rear-facing
installation.
24
Loosen the harness.
1
a Lift the harness adjuster lever located
under the cover flap
b Grasp the chest clip and pull outward
*
Connect the chest clip for easier
adjustment.
Remove the body pillow and
2
unbuckle the harness.
Pull the head restraint cover
3
up, then pull the seat cover
forward to access the rear-
facing belt path.
IMPORTANT: Ensure the buckle is in
inner slot.
Route the vehicle seat belt
4
through the rear-facing belt
slots, ensuring that the vehicle
belt is routed UNDER the
harness buckle strap, then
buckle. Ensure the vehicle belt
is not twisted.
Push down on the middle of
5
the the child seat while pulling
the vehicle belt to remove all
slack.
Rear-facing installations can
6
be improved by the use of
the Versa-Tether (see pages
17 – 19).
Replace the cover.
7
Checklist
9 Check that the vehicle belt is securely fastened.
9 Check that the child seat cannot be moved front to back or side to side
more than 2.5 cm (1 in.) at the belt path. If the child seat is not secure,
repeat installation or use a different seating location.
9 Check that the back angle of the child seat is 30º – 45º from vertical (not
to exceed 45º) when the car is parked on a level surface
* If necessary, the proper recline angle can be achieved by
placing a rolled towel or pool noodle in the vehicle seat bight.
Rear-Facing Installation
1 b
1 a
4
4
5
.
25

Publicité

Chapitres

Table des Matières
loading

Table des Matières