Using The Lower Universal Anchorage System (Luas); Overhang From Vehicle Seat; Harness Mode; Booster Mode - Britax ONE4LIFE CLICKTIGHT Guide D'utilisation

Using the Lower Universal Anchorage System (LUAS)

Ancrages
inférieurs
27,9 cm (11 po)
Siège du véhicule
The Lower Universal Anchorage System or LUAS, is a
system available on this child restraint that offers an
alternative to vehicle seat belt installation methods. The
figure above shows typical locations for lower anchors
and tether anchors in a vehicle. See pages 2-3 for LUAS
components on this child restraint.
Check your vehicle owner's manual to learn if it is equipped
with LUAS, the maximum weight rating for the lower
anchors, tether anchors capacities, and information on the
lower anchor locations and designated seating positions
available for use with this child restraint.
Tether anchor locations vary
from vehicle to vehicle. Check
your vehicle owner's manual
and look for the tether anchor
symbol shown in the diagram
to help identify where the top
tether anchor is located in your
vehicle.

Overhang from Vehicle Seat

Harness Mode

It is important that the base of the child restraint rests
completely flat on the vehicle seat with no side overhang.
It is permissible to allow up to 7.5 cm (3 in.) of the base to
hang over the front edge of the vehicle seat. If the vehicle
seat does not allow enough of the child restraint base to
make contact, adjust the recline angle to a more upright
position. Not doing so could cause the child restraint to not
perform as intended.

Booster Mode

Overhang is not allowed in booster mode. In booster mode, the
base of the child restraint must fit completely on the vehicle seat.
EMPLACEMENT DE L'ANCRAGE DUA
Appuie-tête de
siège de véhicule
Point
d'ancrage
Points d'ancrage
pour une installation
orientée vers l'avant
Enrouleur de ceinture
de sécurité du véhicule
Ceinture à trois points
d'ancrage du véhicule
Ancrages
inférieurs
Or
Or
11