Booster Mode Installation - Britax ONE4LIFE CLICKTIGHT Guide D'utilisation

9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Vehicle belt is locked as directed by your vehicle owner's manual.
9 Base of child restraint sits flat on vehicle seat.
9 Recline indicator is still within the correct section for FORWARD-
facing, after child is secured.
9 Child restraint cannot be moved front to back or side to side more
than 2.5 cm (1 in.) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured.
9 The anti-rebound bar MUST be removed.
NOTE: If the child restraint does not meet the above criteria,
repeat the installation steps or use a different seating
location in your vehicle.

BOOSTER Mode Installation

Britax strongly recommends that children should remain
in a child seat with a 5-point harness until reaching the
maximum weight or height allowed.
Use in BOOSTER
• in recline position "B", and
• with children who weigh 18 - 54
kg (40 - 120 lb), and
• who are between 112 - 160
cm (43 - 63 in) in height or
less, and
• when top of child's ears are
BELOW the top of headrest, and
• when the lap belt sits low across
child's upper thighs when routed
through the belt guide, and
• when the vehicle shoulder belt
lays straight across the child's chest, and
• when the shoulder belt guides are positioned above the
child's shoulders.
Using LUAS in BOOSTER Mode
Use of lower anchors is not required for booster seat
installation. However, lower anchors can be used to secure
child seat in
unoccupied, since in a crash an unsecured child restraint
may injure occupants.
To use this seat in
see instructions for Securing Your Child in Booster Mode on
page 36.
WARNING!
mode only:
BOOSTER mode to the vehicle seat even when
BOOSTER mode without lower anchors,
31