Britax ONE4LIFE CLICKTIGHT Guide D'utilisation page 22

9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and vehicle belt is not twisted.
9 Base of child restraint sits flat on the vehicle seat.
9 Recline indicator is still within the correct section for REAR-facing,
after child is secured.
9 Child restraint cannot be moved front to back or side to side more
than 2.5 cm (1 in.) at the belt path.
9 Both vehicle lap and shoulder belts are routed through the CLICKTIGHT.
9 Excess top tether webbing is contained within your vehicle and secured.
9 Anti-rebound bar installed.
NOTE: If the child restraint does not meet the above criteria,
repeat the installation steps or use a different seating
location in your vehicle.
REAR-Facing Installation with LUAS
Do NOT install by this method for
a child weighing more than 13.6 kg
(30 lb).
1. Open the CLICKTIGHT door.
Squeeze the CLICKTIGHT
release buttons underneath the
front cover flap and lift to open.
2. Open the storage
pocket. Remove the
lower connectors by
pushing the red buttons
and pulling away from
the child restraint.
3. Extend lower connector
strap to its longest
length by pressing grey
button on the lower
connector adjuster.
4. Place the child restraint
REAR-facing on vehicle
seat so that the bottom
of the base sits flat on
the vehicle seat.
5. Recline child restraint to
the appropriate position.
Refer to page 15 to
determine appropriate
recline position.
20