Installation With Vehicle Lap Belt Only - Britax ONE4LIFE CLICKTIGHT Guide D'utilisation

NOTE: Do NOT install by this method for a child weighing
more than 13.6 kg (30 lb).
9 Both red CLICKTIGHT release buttons are visible after installation.
9 All connections are secure and strap is not twisted.
9 Base of child restraint sits flat on vehicle seat.
9 Recline indicator is still within the correct section for REAR-facing
after child is secured.
9 Child restraint cannot be moved front to back or side to side more
than 2.5 cm (1 in.) at the belt path.
9 Excess top tether webbing is contained within your vehicle and secured
9 Anti-rebound bar installed.
NOTE: If the child restraint does not meet the above criteria,
repeat the installation steps or use a different seating
location in your vehicle.

Installation with Vehicle Lap Belt Only

1. Place child restraint
REAR-facing on the
vehicle seat so that the
bottom of the base sits
flat on the vehicle seat.
2. Recline child restraint to
the appropriate position.
Refer to page 15 to
determine appropriate
recline position.
3. Ensure that no more
than 7.5 cm (3 in) of the
base hangs over front
edge of the vehicle seat.
4. Open the CLICKTIGHT
door. Squeeze the
CLICKTIGHT release
buttons underneath the
front cover flap and lift
to open.
22
7.5 cm 7.5 cm