Lap Belt Installation - Britax Roundabout 55 Guide D'utilisation

Rear-Facing Installation

Lap Belt Installation

Before You Begin:
Check that your vehicle belt is compatible for use with child
seats. See pages 6 – 8 for more information.
Recline this child seat to position 3 and place rear-facing on the
vehicle seat (see page 15).
* When properly installed in the rear-facing
position, the back angle of the child seat
maintain head and neck control (not to
level surface. Use the blue line as a guide
to achieve the proper recline angle for rear-
facing installations. The blue line will be parallel to the ground
when the child seat angle is at the center of the angle range (30
placing a rolled towel or pool noodle in the vehicle seat bight.
Britax recommends that the Versa-Tether is used at all times.
Using the tether will improve the stability of the child seat and
reduce the risk of injury. Check your vehicle owner's manual
for tether anchor locations. See page 18 for possible rear-facing
tether configurations.
Install with the lap belt as shown above.
IMPORTANT:
The harness buckle strap should lie toward the back of the
child seat during installation.
DO NOT use lock-offs for lap belt installations.
The buckle should be in the inner slot for rear-facing
installation.
24