Programming The Remote Controls; Memorising The Keygo Io Remote Controls; Memorising The 3-Button Remote Controls; Programming On An Io Light Receiver - SOMFY ELIXO SMART io Manuel D'installation

EN

8. PROGRAMMING THE REMOTE CONTROLS

8.1. Memorising the Keygo io remote controls

8.1.1. Via the programming interface
1) Press the "PROG" button for 2 s.
The "PROG" indicator light is permanently lit.
Pressing "PROG" again allows you to move onto memorisation of the
next function.
2) Briefly press the outer le and right buttons on the remote control
simultaneously.
3) Briefly press the button selected to control the function (complete
opening, pedestrian opening, Aux 230 V output control).
Complete opening control - Fig. 12
Pedestrian opening control - Fig. 26
Aux 230 V output control - Fig. 27
8.1.2. By copying a previously memorised Keygo io
remote control - Fig. 28
This operation is used to copy the programming from a previously
memorised remote control button.
1) Press the outer le and right buttons on the previously memorised
remote control simultaneously until the indicator light flashes.
2) Press and hold the button to be copied on the previously memorised
remote control for 2 seconds.
3) Briefly press the outer le and right buttons on the new remote control
simultaneously.
4) Briefly press the selected button to actuate the drive on the new
remote control.
Key:
Keygo io A = "source" remote control already memorised
Keygo io B = "target" remote control to be memorised

8.2. Memorising the 3-button remote controls

8.2.1. Via the programming interface - Fig. 29
1) Press the "PROG" button for 2 s.
The "PROG" indicator light is permanently lit.
Pressing "PROG" again allows you to move onto memorisation of the
next function.
2) Press "PROG" at the rear of the 3-button remote control to memorise
the function.
The "PROG" indicator light flashes for 5 s.
8.2.2. By copying a previously memorised 3-button
mono-directional io remote control - Fig. 30
A = "source" remote control already memorised
B = "target" remote control to be memorised
8.2.3. Function of the 3-button remote control buttons
Function
Comp. Complete opening Stop
opening
Pedest. Complete opening If the gate is open
opening
Aux 230 V Aux. output ON
9
my
Complete closing
Complete closing
or closed pe-
destrian opening
Otherwise
stop
Aux. output OFF
9. PROGRAMMING ON AN IO LIGHT
RECEIVER
This function enables automatic activation of remote lighting connected to
the receiver during gate movements.
1) Switch the light receiver to programming mode (refer to the receiver
manual).
2) Briefly press the "PROG" button.
The integrated lighting and P0 indicator light flash once.
The lighting connected to the light receiver comes on and then goes
out.
10. CLEARING THE REMOTE CONTROLS
AND ALL SETTINGS

10.1. Clearing memorised remote controls - Fig.

31
Press the "PROG" button (7 s) until the "PROG" indicator light flashes.
Clears all memorised remote controls.

10.2. Clearing all settings - Fig. 32

Press the "SET" button (7 s) until the "POWER" indicator light flashes
slowly.
Clears the auto-programming and resets all parameters to default values.
11. LOCKING THE PROGRAMMING
BUTTONS FIG. 33
Warning
The keypad must be locked to ensure user safety.
Failure to follow this instruction may result in serious injury, e.g.
due to crushing by the gate.
Press the "SET", "+" and "-" buttons simultaneously.
The programming (auto-programming, parameter setting) is locked.
To access the programming again, repeat the same procedure.
Copyright © 2018 SOMFY ACTIVITES SA. All rights reserved.
io Elixo Smart