Changing Cutting Parameters - Struers Discotom-60 Mode D'emploi

Changing Cutting Parameters

Turn knob to select Cutting
Parameter.
Push knob to allow editing of Cutting
Parameter.
Turn knob to adjust value.
Push knob to store new value.
16
Discotom-60 /-65
Instruction Manual
In automatic cutting mode the Discotom applies the selected cutting
parameter values for: Feed speed, Stop mode and Motor RPM (D-65
only).
To adjust the values of these parameters:
 Turn the knob to highlight a selected cutting parameter.
 Push the knob to allow editing of the highlighted parameter. Turn
the knob to change the value of the parameter.
 Push the knob to store the new value.
Actual values of the cutting parameters: Feed speed, Stop position
and Motor RPM (D-65 only) are displayed to the right of the columns
(A).
Turn the knob to change the value of the selected cutting parameter.
The arrow above the column will move to reflect the new setting (B).
A
B