Maintenance Of Cut-Off Wheels; Storing Bakelite Bonded Al; Cut-Off Wheels; Maintenance Of Diamond And Cbn Cut-Off Wheels - Struers Discotom-60 Mode D'emploi

Maintenance of Cut-off Wheels

Storing Bakelite Bonded Al

Cut-off Wheels

Maintenance of Diamond and CBN
Cut-off Wheels
Maintenance of
Clamping Devices
Discotom-60 /-65
Instruction Manual
O Bakelite bonded cut-off wheels are sensitive to humidity. Therefore,
2 3
do not mix new, dry cut-off wheels with used damp ones. Store the
cut-off wheels in a dry place, horizontally on a flat support.
The precision of diamond and CBN cut-off wheels (and thus the
quality of the cut) depends on how carefully the following instructions
are observed:
 Never expose the cut-off wheel to a heavy mechanical load, or
heat.
 Store the cut-off wheel in a dry place, horizontally on a flat
support, preferably under light pressure.
 A clean and dry cut-off wheel does not corrode. Therefore, clean
and dry the cut-off wheel before storing. If possible, use ordinary
detergents for the cleaning.
 Regular dressing of the cut-off wheel is also part of the general
maintenance.
It is recommended to thoroughly clean and lubricate the
Quick Clamping Device and Vertical Clamping Device at regular intervals.
Important
57