Cooling Valve Positions; Flush Hose; Cleaning Of Flush Hose Nozzle - Struers Discotom-60 Mode D'emploi

Cooling Valve Positions

Flush Hose

Cleaning of Flush Hose Nozzle

12
Discotom-60 /-65
Instruction Manual
The cooling valve switches the flow of cooling fluid between the
cutting chamber (cutting) and the flushing hose (cleaning).
During cutting the valve is placed in the vertical position to cool the
cut-off wheel. During cleaning the valve is turned clockwise to divert
cooling fluid to the flushing hose.
Turn the valve anti-
clockwise (dot to top)
for cut-off wheel
cooling.
Turn the valve
clockwise (dot to
bottom) for cleaning.
After cleaning, turn cooling valve back to vertical position. START
not be activated unless the cooling valve is in the cutting position.
 Press down the lever, on the top of the flush hose, to open the
hose's on/off valve and to adjust the flow of water.
For instructions on how to use the flushing hose when cleaning the
Discotom, see "Cleaning".
Do not move the cooling valve to the cleaning position
until the flush hose is pointing inside the cutting chamber.
The flush hose nozzle may collect swarf, inhibiting the flow of cooling
fluid.
To clean, unscrew nozzle head and rinse under clean water.
Cutting position
Cleaning position
Please Note
IMPORTANT

can