Clamping The Workpiece; Positioning The Cut-Off Wheel; Using The Automatic Cutting Table As A Stationary Cutting Table - Struers Unitom-5 Mode D'emploi

Clamping the Workpiece

Positioning the Cut-off Wheel

Using the Automatic Cutting
Table as a Stationary Cutting
Table
6
Automatic Cutting Table for Unitom-5
Instruction Manual
Place the workpiece between the clamp and the back stop of
the automatic cutting table. The protruding part of the
workpiece should pass slightly across the fixed cutting table
on the right-hand side, if possible. Make sure that the sample
does not run into the fixed cutting table when it advances.
Push the clamp against the workpiece and lock the quick-
clamping device with the locking handle.
Do not clamp the sample with the fixed cutting table.
After clamping the workpiece, you may lower the cut-off wheel
to a position at least 1 mm above the workpiece, to test the
correct position of the cut on the workpiece.
Press POSITION DOWN
The cut-off wheel stops when you cease pressing the key.
You can watch the position of the cut-off wheel in the display.
Leave the cut-off wheel in position before you press
s
START .
If you do not want the automatic cutting table to move, set the
number of cuts to 1 and move the automatic cutting table to the
right-hand position.
V
to lower the cut-off wheel.