Connection To An External Exhaust System - Struers Discotom-60 Mode D'emploi

Connection to an External
Exhaust System
8
Discotom-60 /-65
Instruction Manual
Struers recommends the use of an exhaust system, as workpieces
may emit harmful gases when cut. The exhaust system will also
reduce the level of water condensation on the sides of the protection
guard.
To connect the Discotom to an exhaust system:
 Remove the red cap from the flange.
 Mount an exhaust hose from your local exhaust system onto the
flange (50 mm (approx. 2") dia.).
If no exhaust is connected, damp air (produced by the cutting process) may
escape from the cutting chamber and penetrate into other areas of the
cabinet. This may cause damage to components and shorten the lifetime of
Important
the machine.