Trouble-Shooting - Struers Discotom-60 Mode D'emploi

Error
Machine Problems
Machine has stopped cutting.
During cutting the cutting table
stops when reaching a specific
point.
Chamber light does not work.
Water leaking.
Workpieces or cutting chamber
rusty.
44
Discotom-60 /-65
Instruction Manual

4. Trouble-Shooting

Explanation
The AutoStop function is active.
The AutoStop function is active.
Replace the lamp.
Leak in a Recirculation Cooling Unit
hose.
Water overflow in the cooling water
tank.
During cleaning, water has been
sprayed onto unsealed parts of the
cutting chamber
Insufficient additive in cooling fluid.
The protection guard is left closed
after use.
Action
Switch unit off and on at Main
Switch to reset AutoStop.
Switch unit off and on at Main
Switch to reset AutoStop.
Remove plastic cap to gain access
to the fluorescent lamp. Pull out the
lamp and replace it.
Check the hose and tighten the
hose clamp.
Remove the excess water in the
tank.
Avoid spraying unsealed parts of
the cutting chamber during
cleaning, see "Cleaning".
Use Struers Additive for cooling
fluid in the cooling water, at the
correct concentration. Check with a
refractometer. Follow the
instructions in the 'Maintenance'
Section.
Leave the protection guard open to
let the cutting chamber dry.