Struers Discotom-60 Mode D'emploi page 4

Discotom-65
Discotom-60 /-65
Instruction Manual
11. Struers recommends the use of an exhaust system as the materials
being cut may emit harmful gasses or dust.
12. The machine emits only moderate noise. However, the cutting process
itself may emit noise, depending on the nature of the workpiece. In
such cases, the use of hearing protection is recommended.
13. The machine must be disconnected from the mains prior to any service.
14. Use of working gloves is recommended as workpieces may be both
very hot and produce sharp edges. Wearing of gloves is also
recommended when flushing and cleaning the machine.
15. Struers recommends the use of safety shoes when working with heavy
samples.
16. Use of safety goggles is recommended when using the flushing hose.
17. If any of the cutting-chamber hood springs are damaged (at the rear of
machine), they must be replaced before the machine is used again.
18. When a recirculation cooling unit is used, observe the current safety
regulations for handling, mixing, filling, emptying and disposal of the
additive for cooling fluid.
Do not use flammable cooling fluid.
19. When lifting the machine using a forklift, lift from front or rear - never lift
the machine from the side.
20. When lifting the machine using lifting straps, ensure that the straps are
crossed and do not press on the sides of the machine.
1. Prior to any service, disconnect the machine then wait until residual
potential on the capacitors is discharged.
2. Do not cycle mains power more than once every three minutes.
Damage to the frequency converter will result.
The equipment should only be used for its intended purpose and as detailed in the Instruction Manual.
The equipment is designed for use with consumables supplied by Struers. If subjected to misuse, improper
installation, alteration, neglect, accident or improper repair, Struers will accept no responsibility for
damage(s) to the user or the equipment.
Dismantling of any part of the equipment, during service or repair, should always be performed by a qualified
technician (electromechanical, electronic, mechanical, pneumatic, etc.)