Cutting Capacity - Struers Discotom-60 Mode D'emploi

Cutting Capacity

60
Discotom-60 /-65
Instruction Manual
The graph shows the projected cutting capacity under the following
conditions: A new cut-off wheel.
The workpiece is laid directly on the cutting table, with overhang
where appropriate. Vertical clamping is used. The actual cutting
capacity depends on the sample material, cut-off wheel and clamping
technique.
Discotom-60/-65 Cutting
120
100
80
60
40
20
0
0 20 40 60 80 100 120
Depth (mm)
140 160 180 200 220