Burkert 1067 Manuel Utilisateur page 99

APPENDIX
A4 : OPTION BOARD "BINARY POSITION INDICATION/BOOSTER"
(IDENT. 192801): MOUNTING AND CONNECTION
- The positioner must be equipped with the software version F, or higher. Check it in the
main menu, option END: it is displayed at the right-hand side of the screen.
!
- For positioners manufactured before 1996 mounting is only possible if the
motherboard is fitted with black connection blocks (if not, please contact you nearest
Bürkert agent).
Technical characteristics
Positioner
- Operating voltage
- Electric power consumption
- Electric connection
Mounting
- Disconnect the positioner from the voltage supply
- Unscrew the 4 screws of the positioner cover and open the cover
- Remove the 2 red jumpers from the motherboard
- Insert the optional board onto the motherboard (see figure below)
Option board
Make sure the pins correctly slide into the motherboard.
!
- Pass the cables through one of the 2 PG9 cable glands and dismantle them over 6 mm.
: 24 VDC
: max. 30 W
: screw terminals, -
1,5 mm2 cross-
section
pins
Motherboard
E-47-
POSITIONER 1067
Relay
- Contact type : closed
- Commutation current : 0,5 A
Breaking capacity : 10 W
- Contact resistance : 100 mOhm