Burkert 1067 Manuel Utilisateur page 66

3 INSTALLATION
g) Place the cursor of the path-measuring system into the groove
positional transducer and set this spindle onto the spindel of the actuator. Fasten screw
h) Insert electronic board
i) Inside the housing, connect plug
board, with respect to the wire colours (blue mark)
j) Cut cable at the desired length and pull it through the cable gland
positional transducer.
k) Connect cable
l) Tighten the cable gland
m) Screw the housing
Fig. 17 Diagram for the assembly of positioner variant 3 and external feedback/positional
transducer
into the slot of the positioner housing.
of the path-measuring system to the connector of the electronic
to the connector of the electronic board:
- : brown
A : white
+ : green
.
of the external feedback/positional transducer.
12
POSITIONER 1067
of the spindle
11
10
9
8
7
6
5
E-14-
of the feedback/
.
of the external feedback/
1
2
+
3
4