Mount The Vertical Condenser (G3-G6) In The Condenser Bracket - Heidolph Hei-VAP Precision Manuel D'utilisation

−
Push the threaded connection (2) over the condenser flange.
−
Push the spring (3) over the condenser flange.
−
Screw the G6 (6) gland on the drive head (Figure 4-10 (4).
−
Insert the G6 intermediate part (5) with seal G6 (4) into the gland G6 (6).
−
Screw the center piece (1) with the screw (2) on gland G6 (6).
−
Insert the condenser in the upper cut on the center piece (1).
4.5.4

Mount the vertical condenser (G3-G6) in the condenser bracket

This step is omitted for horizontal condensers (G1).
The support rod is installed.
Figure 4-12: Condenser bracket (Glassware set G3 and G6)
1 Support rod
2 Condenser clamp
Version glassware set G3 and G6:
1. Push the boss head clamp (3) onto the support rod (1) and position with the clamp-
ing screw.
2. Place the condenser clamp (2) around the condenser and attach on the support rod
by using the clamping screw.
−
Position the support rod with Allen screws (also refer to chapter 4.5.1).
Version glassware set G5 (depending on coolant):
−
Completely place the cold trap bracket into the lateral hole of the boss head
clamp (2).
−
Lock with the clamping screw.
−
Place the cold trap bracket on the liner cold trap jacket.
−
Position the liner cold trap jacket with the tension band on the cold trap bracket.
−
Position the support rod (1) with an Allen screw (also refer to chapter 4.5.1).
Hei-VAP Precision
1
2
3
3 Boss head clamp
Set-up and Start-up
Condenser mount-
ing
25
EN