Heidolph Hei-VAP Precision Manuel D'utilisation page 24

EN
Set-up and Start-up
Connection ver-
sions
18
In order to operate the equipment in a country with a different
connector system, one can use approved adapters only or have a
licensed electrician replace the plug with one suitable and ap-
proved for the power supply with protective ground connection.
The plug sockets are located on the back of the unit.
The unit is switched off.
The heating bath is installed on the base console.
Figure 4-3: Connections
1 Heating bath unit plug
2 Heating bath connecting line (symbolically without a cable and connector)
3 Power supply connector
Figure 4-4: Heating bath connector
1. Plug the socket of the heating bath connecting cable (2) of the Hei-VAP base into
the appropriate connector (1).
2. Plug the socket (2) with the cap nut (4) of the heating bath connecting cable (7-pin)
into the heating bath:
−
Press the socket into the connector so that the locking stub fits into the groove.
−
Grab the socket (2) on the knurled nut (4) and turn the knurled nut clockwise to
fix it.
3. Plug the power supply cable into the power supply plug on the back panel of the
base unit.
4. Connect the power cable to the power supply.
1 2 3
Hei-VAP Precision