Heidolph Hei-VAP Precision Manuel D'utilisation page 49

9
8
7
6
5
Figure 4-32: Vacuum box (for Hei-VAP Precision)
1 USB PC connection
2 Vacuum pump/Vacuum valve connection
3 Suction side of vacuum
4 Connecting line outlet to the heating bath
5 Vacuum box connection
6 Ventilation / inert gas
7 Hei-VAP connection
8 Switch box connection
9 Bluetooth module
1. Place the vacuum box on the guiderails behind the heating bath. The vacuum box
bracks must be located above the holes.
2. Place the enclosed screws (2 pieces) in the holes with thread through the bracket of
the vacuum box.
3. Tighten the fastening screw.
4. Insert the necessary or applicable connections (2, 3, 4, 5, 7, 8) into the Vacuum box.
Hei-VAP Precision
Set-up and Start-up
Hei-VAP Precision
with vacuum box
1
2
3
4
EN
43