Positioning The Dispersion Tool In The Fluid; Operating Under Pressure Or In A Vacuum With The Sealed Dispersion Tool; Connecting The Power Supply (Unit) (S) - Heidolph SilentCrusher M Mode D'emploi

6. Positioning the Dispersion Tool in the Fluid

The dispersion tool, with the drive unit and the vessel retainer, can be positioned correctly by
loosening the knurled screws 1 and 2 (F and H) on the sleeve coupling and moving the retainer
rod. Retighten the knurled screws 1 and 2 (F and H) on the sleeve coupling (E).

7. Operating under Pressure or in a Vacuum with the Sealed Dispersion Tool

When operating under pressure or in a vacuum with the sealed tool, always posi-
tion the stator shaft in the fluid so that the upper hole (TT) in the stator shaft is
always above the level of the fluid.
If the hole (TT) is below the level of the fluid, fluid can enter the upper area of the
dispersion tool due to the change in pressure conditions and damage it.

8. Connecting the Power Supply (unit) (S)

Connect the Power Supply (unit) (S) to the drive unit (U) with the small plug (T).
Z
U
V
TT
Connect the power connection cable (V) to the receptacle (X) with the plug (W). Place the
switch (Y) in the "0" position and turn the knob (Z) all the way to the left stop.
T
Y
X
W
- 37 -
S
E
E