Connect The Base Unit - Heidolph Hei-VAP Precision Manuel D'utilisation

Location of the heating bath when using Rotacool
The base unit is located on a suitable surface.
Verify that sufficient space (approx. 20 cm around the evapo-
rator) and a solid seating are available in the shifting area and
the Rotacool.
Verify a solid seating of the heating bath base and the bath as
well as the Rotacool extension.
1. Place the two screws on the right side of the extension plate of the Rotacool.
(Contact a local Heidolph Distributor if using a previously purchased Rotacool before
July, 2009 for proper attachments of the extension plate.
2. Check the extension plate (2) for proper seating.
4.4.5

Connect the base unit

CAUTION
Supply voltage and the voltage information on model tag do not
match!
Damage due to incorrect voltage.
Verify that the voltage specified on the model tag corres-
ponds with the mains voltage.
Only disconnect the basic device with the heating bath if the de-
vice is de-energized. Unplug main power supply.
CAUTION The drive unit and the heating bath may be switched on acci-
dentally!
Injuring and burning hands.
Risk of entanglement
Injuries to hands.
Verify that the power switch for the base unit and the heating
bath is switched off by the rocker switch.
Country-specific equipment connection cable
The design of the equipment is equipped with a Euro connector
(EN 50075) for 230/240 V by default, and with a US standard plug
(NEMA Pub. No. WDI. 1961 ASA C 73.1 for a design for 120 V.
1961, page 8, 15 A 125 V).
The main power cable of the device has an integrated protective
ground connection.
Please note if the appropriate equipment connection cable for
your country was included and use it.
Equipment connection cable for:
−
−
−
−
Hei-VAP Precision
EU
Great Britain
Switzerland
USA
Set-up and Start-up
Connect the base
unit
17
EN