Operation Of The Hei-Vap Precision - Heidolph Hei-VAP Precision Manuel D'utilisation

6 Operation of the Hei-VAP Precision

The basic steps of operating the rotary evaporator Hei-VAP Precision will be explained in
this chapter.
The parameters for the distillation are set and monitored via the control panel.
The set parameters are stored. The last used parameters will appear after a restart.
8
7
Figure 6-1: Control panel of Hei-VAP Precision (with Motor Lift)
1 Pushbutton for the button activation of soft key display
2 Menu line of programs
3 Pushbutton heating bath on/off (hard key)
4 Soft key display functions
5
Pushbutton rotation start/stop (hard key)
6
Rotary pushbutton controller (Hei-GUIDE)
7 Pushbutton lift down
8 Pushbutton lift up
The actual value display is always the start screen. All current actual values are dis-
played as large numbers and the target values as small numbers.
The programs of the top menu bar are highlighted by turning the rotary pushbutton con-
troller Hei-GUIDE. The Hei-GUIDE walks through the programs going from left and right.
An "<" or ">" shows the direction in which the rotary pushbutton controller can be turned,
in order to reach the non-visible menu elements.
The highlighted menu element is activated by pressing the Hei-GUIDE and the status
screen changes to the respective menu.
The user can change the displayed settings in these menus.
Turning the Hei-GUIDE is sufficient to change between individual entries. The selected
entry is always highlighted.
The selected entry will be called up when pressing the Hei-GUIDE. The desired value
can be set when turning the Hei-GUIDE.
The lower functions in the menu are activated via the grey softkeys.
Hei-VAP Precision
Operation of the Hei-VAP Precision
Control panel of the
base unit / heating
bath
2
4
1
3
5
6
EN
45