Setting The Preparation Parameters - Struers TegraPol 11 Manuel D'instructions

Setting the Preparation
Parameters
24
TegraPol-11/ -15
TegraForce-1
Instruction Manual
Before starting the preparation process, the disc speed, preparation
time, force and water application need to be specified. This is done
using the control panel software:
If a TegraDoser-5 is mounted on the TegraForce and connected to the
TegraPol, then refer to the TegraDoser-5 instruction manual for the correct
procedure for setting the preparation parameters.
If the MAIN MENU is not currently displayed, press Esc

until the MAIN MENU appears

Use the Arrow buttons


Note!
to select Preparation:
