Pause Between steps
TegraPol-11/ -15
TegraForce-1
Instruction Manual
This function can only be used when a TegraDoser-5 is connected.
When two following preparation steps are based on the same
surface, suspension and lubricant, these two steps will be joined so
that the preparation continues directly from one step to the next. The
advantage is that force and dosing level can be changed from one
step to the next without having to restart the machine.
However, it may be desirable to stop the machine, e.g. when using
two subsequent steps on SiC with the same grit size. Therefore it is
possible to set the Pause between steps function to Yes.
Press ENTER
Use the Arrow buttons
Configuration.
Press ENTER
Configuration pop-up menu.
Use the Arrow buttons
steps and press ENTER
to activate the CONFIGURATION Menu.
to select Machine
to activate the Machine
to select Pause between
to toggle between Yes and No
27