Force Reduction - Struers TegraPol 11 Manuel D'instructions

Force Reduction

26
TegraPol-11/ -15
TegraForce-1
Instruction Manual
As soon as the TegraForce is connected, some additional topics are
available in the Configuration Menu. Therefore the Configuration
Menu is also divided into two parts, General Configuration and
Machine Configuration.
Force Reduction is used to decrease the force gradually during the
last 30 seconds of the preparation time. The force is reduced in steps
of 5 N until the final force of 10 N is reached. Thus the surface finish
is finer and the preparation time in the following step can be reduced.
Force Reduction can be set to either On or Off and this setting is
valid for all the preparation steps carried out.


Press ENTER


Use the Arrow buttons

 Configuration.


Press ENTER
Configuration pop-up menu.


Use the Arrow buttons


and press ENTER

to activate the CONFIGURATION Menu.
to select Machine


to activate the Machine
to select Force Reduction


to toggle between ON and OFF.