Setting Preparation Parameters - Struers TegraPol 11 Manuel D'instructions

Setting Preparation Parameters

34
TegraPol-11/ -15
TegraForce-1
Instruction Manual
When a TegraDoser-1 has been fitted to the TegraPol / TegraForce
system, the dosing level must be set. This is done using the control
panel software:
The dosing parameters are only displayed when the water parameter is set

With the Preparation Menu already displayed:
Within this menu, there are 2 new preparation parameters,

Doser No. and Level.
Options
Water
Doser No.
Level
Use the Arrow buttons


level and press ENTER

The TegraPol software is now ready to begin the preparation
process.
All preparation parameters set in this menu are remembered by the
firmware in the TegraPol together with the bottle ID of the TegraDoser.
When the TegraDoser is used on another machine, a different set of
parameters can be set as it is the TegraPol that records the information,
Note:
to OFF.
Settings Comment/Change Increment
ON or OFF Must be set to OFF to use
dosing feature (is automatically
set to OFF when a
TegraDoser-1 is inserted)
0 – 9
indicates ID setting of rotary
switch on TegraDoser
0 – 20
to select the desired dosing


to confirm.
Note
not the TegraDoser.
Information only:
1