Disc Margin - Struers TegraPol 11 Manuel D'instructions

Disc Margin

20
TegraPol-11/ -15
TegraForce-1
Instruction Manual
Before final tightening of the two fastening screws or the bottom nut
you must check the margin between the specimen holder plate hole
and the edge of the grinding / polishing disc. This distance should be:
Diameter of the Holes
40 mm
1½"
1¼"
30 mm
25 mm
Having adjusted the disc margin, tighten the two fastening screws firmly.
Make sure that the distance between disc and specimen mover plate still is
correct. The column should now remain in position.
Mount the two caps on the holes for the fastening screws.

Disc Margin
1.5 mm
2.5 mm
6.0 mm
6.5 mm
9.0 mm
IMPORTANT