Power Supply Connection; Initial Start-Up And Electrical Connection Check - moovo XW4 Instructions Et Avertissements Pour L'installation Et L'utilisation

STEP 7
WARNINGS
– The PVC power supply cable supplied with the product is ide-
al for internal installation; an insulated tube must be used to
protect the cables when installed outside, or the specific
H07RN-F type cable can be requested to replace this version
if required.
– Final connection of the automation to the mains or replace-
ment of the cable supplied must be performed by a skilled and
qualified electrician, in observance of local current safety
standards and the instructions in the section "Tasks reserved
for qualified technicians".
To perform the automation operation and programming tests, insert the
power plug of the control unit (supplied) in a mains socket (fig. 50). If
the socket is far from the automation, use a suitable extension lead.

INITIAL START-UP AND ELECTRICAL CONNECTION CHECK

STEP 8
CAUTION! – The following operations described in this manual will
be performed on live electrical circuits and therefore manoeuvres
may be hazardous! Therefore proceed with care.
After powering up the control unit (fig. 50), the red led and green led (fig.
51) emit a series of flashes.
At the end of this phase, the red led starts flashing at regular intervals.
This confirms correct operation of the control unit.
51
"L1" red led
Key "P1"

POWER SUPPLY CONNECTION

50
CAUTION! – If the red led does not flash as described above, dis-
connect the Control unit from the power supply and carefully check
all connections (refer also to the paragraph "What to do if....").
"L2" green led
English – 21