Knowledge Of The Product And Preparation For Installation; Product Description And Intended Use; Components Used To Set Up Acomplete System - moovo XW4 Instructions Et Avertissements Pour L'installation Et L'utilisation

KNOWLEDGE OF THE PRODUCT AND PREPARATION FOR INSTALLATION

STEP 2
2.1 – PRODUCT DESCRIPTION AND INTENDED USE
The series of devices that make up this product serve to automate a 2-
leaf gate or door (fig. 1a). It may also be used to automate a single leaf
gate or door (fig. 1b).
Any other use than as specified herein or in environmental condi-
tions other than as stated in STEP 3 is to be considered improper
and is strictly prohibited!
The main part of the automation comprises two electromechanical gear-
motors each equipped with a 12 V dc motor and a worm gear. One of the
gearmotors is also fitted with a control unit.
The control unit governs all devices present in the automation and man-
ages all relative functions. It is made of a board and incorporated radio
receiver which receives the commands sent by a transmitter. It may also
be controlled via a wall-mounted keypad or a pair of photocells set with
the single opening command.
The control unit is able to manage different types of manoeuvre, each pro-
grammable and usable according to specific needs.
Other special functions are also available to enable personalisation of the
automation parameters.
The automation is designed for use of various accessories that enhance
functionality and guarantee optimal safety. In particular, the control unit
can memorise up to 150 keys of MT4 transmitters; up to 4 MK control
keypads or alternatively up to 4 pairs of MP photocells, set for the open-
ing command only.
Connections of the various devices are by means of the "Bus" system.
This system reduces complexity of the connections between devices, as
it envisages the use of a single cable between one device and another.
The product is mains powered and in the event of a power failure it
enables manual release of the gearmotors for manual movement of the
gate leafs.
1a
2
a
e f
b
g h
In this situation, the gate can also be opened using the buffer battery (MB
model) if fitted on the system.
2.2 – COMPONENTS USED TO SET UP A
COMPLETE SYSTEM
fig. 2 illustrates all components used to set up a complete system, such
as that shown in fig. 8.
WARNING!
Some components shown in fig. 2 are optional and may not be
supplied in the pack.
List of components:
[a] - Electromechanical operator with control unit
[b] - Electromechanical gearmotor without control unit
[c] - Front brackets (for fixing gearmotors onto gate)
[d] - Rear brackets (for fixing gearmotors onto wall)
[e] - Keys for manual release of gearmotors
[f] - Pair of photocells model. MP (for wall-mounting)
[g] - Control keypad model. MK (for wall-mounting)
[h] - Portable transmitter model. MT4
[i] - Flashing light model. MF
[l] - Metal hardware (screws, washers, etc.)
[m] - Back-up battery model. MB
1b
c d
i l m
English – 5