Check All Tools Required For The Work; Complete Set-Up Work; Preparing The Electrical Cables - moovo XW4 Instructions Et Avertissements Pour L'installation Et L'utilisation

The possible connection layouts are the following:
– "star": In this configuration, each device is autonomous as it is connect-
ed directly to the two Bus terminals on the control unit.
– "chain": In this configuration one device is connected to another and
the latter to another and so on, like links of a chain. Therefore only the first
device in the chain is connected to the two Bus terminals on the control
unit.
– "mixed": This configuration comprises a combination of the two config-
urations described above.
To select the most suitable connection configuration for the connection of
all system devices, refer to the example shown in fig. 9 / fig. 22. In gener-
al, it is recommended to connect the flashing light as the first device con-
nected to the control unit.
4.1.6 – Check all tools required for the work
Before starting installation, ensure that there is all equipment and materi-
als required for the work concerned (see example in fig. 10); also ensure
that all items are in good condition and comply with local safety stan-
dards.
4.1.7 – Complete set-up work
Lastly, dig the routes for the ducting used for electrical cables, or alterna-
tively external ducting can be laid, after which the pipelines can be
embedded in concrete and other preparation work for the installation can
be completed to finalise the site ready for subsequent installation opera-
tions.
CAUTION! – Position the ends of the ducting used for electrical
cables at the points envisaged for fixture of the various components.
Note:
• The ducting serves to protect electrical cables and prevent accidental
damage in the event of impact.
• The "fixed" control devices must be visible from the gate but positioned
far from moving parts.
4.2 – PREPARING THE ELECTRICAL CABLES
When preparing the electrical cables required for your system, please
refer to fig. 9 and "Table 1 – Technical characteristics of the electric
cables". In addition to this, you should always remember the following:
10
– In the "star" configuration, NONE of the individual cables linking up
any of the devices to the Control Unit may exceed 20 m in length.
– In the "chain" configuration", the sum of the lengths of each cable
used to connect one device to the other and, last of all, to the Con-
trol Unit MUST NOT exceed 20 m.
– All operations to lay the electric cables and connect them to the
various devices must be carried out during installation of the com-
ponents.
English – 9