Programming Mode - Burkert 8624 Instructions De Service

7.3

Programming mode

NOTE:
è Hold down this key for 2 seconds.
è Change the currently-adjusted value (blinks).
è Move to the next position.
è After reaching the last value, you exit the programming mode
NOTE:
Operating Manual No. 800 215
As only the control unit is in the Programming mode, the
pressure controller continues to work with the old values until the
Programming mode is exited.
The control unit is now in the programming mode.
Each position can be individually adjusted in the sequence of
chapters 7.3.2 to 7.3.9.
and return to the Standard mode.
When you leave the Programming mode, the currently-set values
will be saved, and a Reset carried out.
Attention: any current control function will be interrupted!
33