7.3.3.1
Lower limit value
è Limit the lowest control range using the lower limit value
NOTE:
If a signal less than 4 mA is read in, error message E.01
appears.
Setting the pre-comma value of the lower limit value
Setting the post-comma value of the lower limit value
7.3.3.2
Upper limit value
è Limit the upper control range using the upper limit value
NOTE
If a signal larger than 20 mA is read in, error message E.01
appears.
Setting the pre-comma value of the upper limit value
Setting the post-comma value of the upper limit value
36
Increase of the pre-comma value
Proceed to set the post-comma
value
Increase of the post-comma value
Continue from
7.3.3.2
Increase of the pre-comma value
Proceed to set the post-comma
value
Increase of the post-comma value
Continue from 7.3.4
Type 8624