Upper Limit Value - Burkert 8624 Instructions De Service

Setting the pre-comma value of the lower limit value
Setting the post-comma value of the lower limit value
7.3.7.2

Upper limit value

è Limit the upper control range using the upper limit value
NOTE:
With external set-values (standard signals) the error message
E.02 appears as soon as a signal larger than 20 mA is read in.
Setting the pre-comma value of the upper limit value
Setting the post-comma value of the upper limit value
Operating Manual No. 800 215
Increase of the pre-comma value
Proceed to set the post-comma
value
Increase of the post-comma value
Continue from
7.3.7.2
Increase of the pre-comma value
Proceed to set the post-comma
value
Increase of the post-comma value
Continue from 7.3.8
39