Operation; Programming Of K-Factor - Burkert 8021 Notice D'utilisation

4 OPERATION

Programming the Pulse Divider 8021 requires the entry of a factor K and of a multiplicator
D. These parameters are programmed through rotary switches and jumpers (see fig.3).
To access to electronic board, unscrew the central screw and remove the cover.
4.1 Programming of factor K
Enter here the factor K (pulse/liter) corresponding to fitting DN and material (see fig. 4 &
5). 3 rotary switches and 3 jumpers are available for these entries. Each rotary switch
corresponds to a factor K digit and each jumper position to a decimal point position.
Factor K from 0,000 to 999 can be programmed.
Example 1: K=46,6 puls/l (DN25 PVC)
Programming will be as follows:
0
Example 2: K=0,517 puls/l (DN150 SS)
Programming will be as follows:
0
Example 3: K=11,46 puls/l (DN50 SS)
Programming will be as follows:
0
The fourth digit is not taken into account.
The factor K must be confirmed by a reset (short-circuit on jumper 8).
!
0 0
0 0
0 0
PULSE DIVIDER TYPE 8021
1, 2, 3 rotary switches for factor K programming.
5, 6, 7 jumpers for decimal position of factor K.
4 rotary switch for multiplicator D
programming.
8 reset jumper.
Fig.3 Electronic board type 8021
-16-
8021