Burkert 8624 Instructions De Service page 45

NOTE
è To exit the Set-up mode, press down both keys at the same
NOTE
ATTENTION!
42
The minimum opening angle has been reached at the last
moment before the valve opens, i.e., immediately before the
start of the flow.
time.
The unit saves the set values, and changes to the Standard
mode,i.e., the Programming mode is also exited.
You can remove the control unit from the compact pressure
controller, e.g., after programming, without affecting the set
process.
The programmed values remain stored in the pressure controller.
Protection class IP65 is only guaranteed with the housing
closed!
è For this reason, always replace the housing lid and screw
it down tightly.
Typ e 8624