Operation Without The Type 8624-B Control Unit; Operation With The Type 8624-B Control Unit - Burkert 8624 Instructions De Service

6

OPERATION WITHOUT THE TYPE 8624-B CONTROL UNIT

After switching on the operational voltage, the controller works with the preset
parameters (Page 27).
NOTE
7

OPERATION WITH THE TYPE 8624-B CONTROL UNIT

NOTE
ATTENTION!
When operating with the control unit, four modes are possible:
• Standard mode
• Programming mode
• Manual mode
• Set-up mode
Measure:
è Switch off the supply voltage:
è Insert the Type 8624-B control all necessary data will be transferred from
unit:
è Switch on the supply voltage:
è Selected the required mode:
è Close the current mode:
Operating Manual No. 800 215
Changing the parameters or re-configuring the inputs is only
possible with the Type 8624-B control unit.
You can install the Type 8624-B control unit onto the Type 8624
compact pressure controller in place of the lid, turned by 180°.
When installing the Type 8624-B control unit, the supply
voltage must be switched off, as otherwise a re-programming
and thereby a loss of function of the Type 8624 pressure
controller can take place.
Result:
the parameters last set will be saved.
the pressure controller into the control unit,
and be stored
the Standard mode is activated (see 7.2)
Programming, Manual or Set-up mode will be
activated (see 7.3 to 7.5)
the data that has been set up will be
transferred from the Type 8624-B control unit
to the Type 8624 pressure controller.
29