Publicité
Les langues disponibles
Les langues disponibles
or
When switched on, the motorised product does not move
B
b1
according to the reaction of the motorised product.
b1
The motorised product still does not move
is programmed.
Follow the procedure in the section
Pre-programming the Somfy io-homecontrol
control point.
or
b2
The motorised product is fully raised or lowered
programmed.
2.3.1. Pre-programming the Somfy io-homecontrol
-
control point is pre-programmed in the drive.
2.3.2. Checking the direction of rotation
1)
a) If the motorised product is raised, the direction of
the automatic settings.
b) If the motorised product is lowered, the direction of
2)
of rotation is changed.
3)
1)
down.
2)
.
Press the io-homecontrol
®
3)
control point has been programmed.
Copyright © 2014 Somfy SAS. All rights reserved.
EN
ON
b1
or
b2
or
b2
Pre-programming
the Somfy io
local control
®
local
point
Use and
maintenance
®
local control point
ON
0.5
S
1)
a
automatic settings
b
Move onto the next
step
2)
3)
1)
2)
3)
PROG.
25
Images not contractually binding
EN
2.4. TIPS AND RECOMMENDATIONS FOR INSTALLATION
2.4.1. Questions on the OXIMO 40 AUTO io?
Observations
Possible causes
The wiring is incorrect.
The drive is in thermal protection
mode.
The motorised
The io-homecontrol
®
control point
product does not
battery is low.
operate.
The control point is not compatible.
The io-homecontrol
®
control point
used has not been programmed into
the drive.
The OXIMO 40
The OXIMO 40 AUTO io is too close
AUTO io drive
to its end limit positions or to the last
rotates in one
obstacle encountered.
direction only.
The roller shutter
mounting on the
roller tube must be
The favourite
The travel of the motorised product has
position has shifted.
been changed.
2.4.2 Changing the direction of rotation
The direction of rotation may be changed at any time using a paired Somfy io-homecontrol
1)
Position the motorised product at the mid-height position.
2)
down.
3)
4)
26
Images not contractually binding
Solutions
Check the wiring and modify it if necessary.
Wait for the drive to cool down.
Check whether the battery is weak and
replace it if necessary.
Please contact a Somfy adviser.
Use a programmed control point or program
this control point.
V
Press
or
to unlock the OXIMO 40 AUTO
io.
To change the installation (position of
the bolts), restore the default settings
of the OXIMO 40 AUTO io and repeat
the full installation procedure from the
Commissioning section.
Wait for automatic resetting at the end of
several cycles or repeat the full installation
procedure on the OXIMO 40 AUTO io from
the Installation section.
®
control
1)
2)
3)
4)
Copyright © 2014 Somfy SAS. All rights reserved.
Publicité
Chapitres
