Tips And Recommendations; Questions On The J4 Io - SOMFY HOME MOTION J4 io Notice Installateur

8. TIPS AND RECOMMENDATIONS

8.1. Questions on the J4 io?

Observations
The blind does not
operate.
The blind stops too
soon or too late.
Despite the presence
of a sunlight sensor,
when the sunlight is
low the blind does
not tilt the slats to the
horizontal position.
I can't tilt the slats
easily.
I can't tilt the slats
properly.
The"my" position is
not working.
My "my" position
cannot be repeated.
The blind (or one of
several) does not
react as described
in the manual during
pairing or setting.
70
Possible causes
The wiring is incorrect.
The motor is hot.
The Somfy io control point battery
is low.
The control point is not compatible.
The Somfy io control point used
has not been programmed into the
actuator.
The end limits have been incorrectly
set.
The sensor is not paired/set.
The sensor is paired/set.
The "my" position is cleared.
The remote control is not
compatible.
The angular travel is incorrectly set. Readjust the angular travel.
The "my" position is cleared.
The angular travel is incorrectly set. Readjust the angular travel and then reset
Pairing or setting has been not
executed correctly.
Check the wiring and modify it if necessary.
Wait until the motor cools down.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed control point or program
this control point.
Readjust the end limits.
Read the sensor manual to carry out the
pairing and appropriate settings
Readjust the angular travel.
Set the "my" position.
Pairing and using a Situo mobile io VB/Easy
Sun io/Composio io/Smoove io remote
control.
Set the "my" position.
the "my" favourite position.
Only cut shortly the power and repeat the
procedure if necessary.
© 2011 Somfy SAS. All rights reserved. 11/2011
Solutions